This is a collaborative project with (Cinderwings)
A cute little mushroom dragon with its own shelf.

Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups.

The holder has a screw-hole diameter of 5.5 mm. If you want a huge version, scale up the shelf and use the holder_for_upscaling – the only difference is the screw-hole size of 3mm that will be usable when scaled.

Instructions for single color
Print your dragon, the top, bottom and holder of the shelf
Print as many spots for our shelf as you want. They are provided in three different sizes
Glue the top onto the bottom
Glue on your spots
You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.

Instructions for multi color
Print your dragon, shelf and holder
You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.