This is a bundle of a gingerbread couple modeled to be floppy, non-floppy, ornaments, earrings, and magnets!

Two magnet versions are available. One version uses a 15x2mm magnet and the other uses an 8x3mm magnet.

There are two versions of the earrings. One version has the gingerbread person face and buttons on one side and the other has the face and buttons on bottom and top so it's two sided.

Printing Instructions:
The 3mf files provided were created using Bambu Studio and should have the following settings already configured.

Layer height: 0.2mm
Supports: None
Wall loops: 3
For the Floppy Gingerbread People, make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also helps, but not guaranteed to work.

Thank you for your time and consideration on this matter.

Feel free to join my discord (https://discord.gg/uqJwERhbxf) for additional support, questions, or suggestions!