A paper towel holder with a great tear-off experience. It is fully enclosed, so your towels don’t get wet and stay hygienic.

Sizes
A: Fits rolls with a width up to 110 mm in diameter and 260 mm in height. It has addition 6 mm in clearance so slightly bigger or deformed rolls work, too. This fits the most common EU Sizes.
B: Fits rolls with a width up to 140 mm in diameter and 280 mm in height. It has addition 6 mm in clearance so slightly bigger or deformed rolls work, too. This fits the most common US Sizes.

Instructions
Choose your version
Print all parts
Optional: Print the TPU feet and glue them into the bottom, you can also use store bought rubber feet with a diameter of up to 8 mm.
Push your roll onto the center bottom
Insert it into the bottom while already guiding the first paper towel through the slit
Add the top to the center top and connect them with the screw
Place the top assembly onto the bottom assembly while guiding the paper towel through the slit.

Usage
Place one hand on top so you can use or block the rotation.
Unroll the Paper towels until the perforation slightly sticks out.
Block the rotation and tear off the paper at an angle.
You can retract or push out the paper with the knob on top
If your roll gets stuck, you can use the center notch to grab it.
If it is stuck even further inside, you can lift the top half of the assembly to fix the paper towels in place.