A selection of 4 3D scanned red banded bracket mushrooms that I collected over multiple years and two countries.
I split them up into their color zones so you can print them with a single-color setup, but I also made painted-on multi-color 3MFs! If you want the entire mushroom in on color, those are also included.

Instructions split multi-color print
Print all parts
Insert the connectors into the bottom layer
Apply glue to the flat surface
Add the other two parts and press them together for a bit
You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation. The screw-hole diameter is 5.5mm.


Instructions multi color or single-color print
Print all parts
You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation. The screw-hole diameter is 5.5mm.


I scaled the mushroom to 70% of their original size, if you want to scale them back up, use the holder_for_upcaling - the only difference is the screw-hole size of 3mm that will be usable when scaled.