One of the world’s most famous mushrooms embodied in a naturalistic lamp design.

Instructions
Get the Bambulab LED lamp kit 001 or a similar sized LED puck or cabinet light kit from a different manufacturer – check the cross-section image for measurements.
Print the cap in a non-translucent filament, preferably red.
Print the Stem, 21 Insert_A and 25 Insert_B in a light-colored or transparent filament, preferably white. The areas where the light shines through are 1.6 thick. You can print a test piece of this horizontal thickness to evaluate the translucency of your filament by holding the light behind the print.
Print the holder.
Glue the holder into the cap.
Attach the lamp with the double-sided tape (from the lamp kit) to the holder.
Funnel the wire through the stem.
Click the Stem into the Cap.
Enjoy your new lamp!
In case your LED breaks one day you can dissemble the design by remove the stem with a pencil or screwdriver that you insert into the hole of the cap and lift it up. Remove the broken LED and replace it with a new one

Size assembled: 150 x 150 x 200 mm